Drawmer-electronics MC2.1 Monitor Controller Manuel d'utilisateur télécharger pdf (Page 6)

DRAWMER

INSTALLATION

The MC2.1 is a free standing, desktop unit, with controls and headphone jacks on

the front panel and all other inputs and outputs on the rear. Multiple units can be

stacked whilst sitting on the desk, however, the MC2.1 can be screwed to the desk

or into a standard 19” rack (using a 2U mounting kit).

Note that whether fixing to a desk or to a rack the speaker trims on the base of the

unit will not be accessible and so the calibration procedure should be carried out

before fastening the MC2.1 in place (see ‘Monitor Calibration’).

Screwing the MC2.1 to

a desk.

Rather than having the

MC2.1 free standing it

can be fastened down to

a desk by utilising the

holes that hold the

rubber feet to the

underside.

Drill four holes into the

desk, at 4mm in

diameter and to the

dimensions as shown in

the diagram. (Note that

the diagram is viewed

from above).

Pushing four screws

through the under-side

of the desk screw the

MC2.1, including the

rubber feet, to the panel

to secure. The screws

should be M3 and have

a length of 14mm plus

the thickness of the panel.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Pas de commentaire

Drawmer-electronics MC2.1 Monitor Controller Manuel d'utilisateur Page 6